Skip to main content
DMV Test Free

Rhode Island CDL — General Knowledge practice

Rhode Island CDL — General Knowledge: Right-of-Way practice test

Who goes first at intersections, four-way stops, roundabouts, and crosswalks, and how to yield to pedestrians and emergency vehicles.

Content reviewed against official driver handbooks · August 12, 2026

13 questions · pass with 10 correct. You get instant feedback and an explanation after every answer.

Choose your level

Up to 20 questions on this topic, with feedback after every answer.

Study questions with answers

12 sample Right-of-Way questions with the correct answer, a short explanation, and the official handbook reference. Read through them, then take the quiz above.

Show all 12 questions with answers
  1. 1. What two things should govern your speed as you near a railroad crossing?

    Correct answer: How far you can see trains coming, and being able to stop short of the tracks

    Reduce speed according to how far you can see approaching trains in each direction, and keep it low enough to stop short of the tracks if a stop is needed.

    Source: Rhode Island CDL Manual — Section 2: Driving Safely (Railroad-highway Crossings)

  2. 2. On the road test, which of these is forbidden once your vehicle has started across a railroad crossing?

    Correct answer: Pass another vehicle

    Until the whole vehicle is past the tracks, you may not stop, shift gears, pass anyone or switch lanes.

    Source: Rhode Island CDL Manual — Section 13: On-road Driving (Railroad Crossing)

  3. 3. A driver who feels your truck is making them late may do which of these?

    Correct answer: Pass without a safe gap in oncoming traffic and cut in close in front of you

    Hurried drivers may pass without enough room in oncoming traffic and cut too close in front of you. Watch for them.

    Source: Rhode Island CDL Manual — Section 2: Driving Safely (Seeing Hazards — Drivers Who Are Hazards)

  4. 4. On the road test, what should you do once you are on an expressway exit ramp?

    Correct answer: Keep slowing within the lane markings and leave space between you and other vehicles

    When exiting, make traffic checks, signal, and slow smoothly in the exit lane. On the ramp, keep decelerating within the lane markings and keep adequate spacing.

    Source: Rhode Island CDL Manual — Section 13: On-road Driving (Expressway or Rural/Limited Access Highway)

  5. 5. A heavy load is slowing you down on a multilane highway. Where should you drive?

    Correct answer: In the right lane, if possible

    Drivers stuck behind slow heavy trucks often tailgate. If your load is holding you back, stay in the right lane when you can.

    Source: Rhode Island CDL Manual — Section 2: Driving Safely (Managing Space)

  6. 6. On a multiple-lane road during the road test, in which lane should you finish a left turn?

    Correct answer: The lane just to the right of the center line

    The lane usage rules say a left turn should end in the lane just right of the center line, while a right turn should end in the curb lane.

    Source: Rhode Island CDL Manual — Section 13: On-road Driving (Lane Usage)

  7. 7. Pulling back into traffic after the road test's stop/start maneuver, which direction does the manual say to check especially?

    Correct answer: To the left

    When resuming, check traffic all around, especially on your left, and then ease into the proper lane once it is safe.

    Source: Rhode Island CDL Manual — Section 13: On-road Driving (Stop/Start)

  8. 8. On the road test, what should you do as you drive through an intersection?

    Correct answer: Yield to pedestrians and traffic already in the intersection, and stay in your lane

    While crossing an intersection, check traffic all around, slow and yield to pedestrians and vehicles already in it, keep your hands on the wheel, and do not change lanes.

    Source: Rhode Island CDL Manual — Section 13: On-road Driving (Intersections)

  9. 9. The manual's move-over guidance covers approaching an emergency vehicle that is stopped beside the road. What other situation does it cover?

    Correct answer: A work zone

    Approaching either a stopped emergency vehicle or a work zone, slow down and move to a lane not next to it when traffic and safety allow. If you can't change lanes, slow down and proceed with caution.

    Source: Rhode Island CDL Manual — Section 2: Driving Safely (Seeing Hazards — Hazardous Roads)

  10. 10. Why should you watch other drivers who are themselves in a conflict?

    Correct answer: Their reaction to that conflict may put them in conflict with you

    When other drivers must change speed or direction to avoid hitting someone, how they react may bring them into your path.

    Source: Rhode Island CDL Manual — Section 2: Driving Safely (Seeing Hazards — Drivers Who Are Hazards)

  11. 11. You are about to pull onto a highway in a heavily loaded truck. What adjustment should you make?

    Correct answer: Wait for a bigger gap, since a heavy load slows your acceleration

    Big vehicles pick up speed slowly, so they need a far bigger opening in traffic than a car would. Load affects acceleration, so leave extra room when you are heavy.

    Source: Rhode Island CDL Manual — Section 2: Driving Safely (Managing Space)

  12. 12. On the road test, which steps come before you merge onto an expressway?

    Correct answer: Check traffic and signal properly, then merge smoothly into the correct lane

    Before entering an expressway, check traffic, use the proper signals, and merge smoothly into the proper lane.

    Source: Rhode Island CDL Manual — Section 13: On-road Driving (Expressway or Rural/Limited Access Highway)

Take the full CDL — General Knowledge practice test

More CDL — General Knowledge topics

Practice Right-of-Way in another state

Every Rhode Island question is written from the official Rhode Island driver handbook and checked against its current edition. DMV Test Free is a free, independent study resource — not affiliated with any DMV or government agency. About DMV Test Free